The crest is an etching I purchased from the original AJ Reeves in Birmingham.
The crest was first drilled for a fret saw blade and then trimmed on a guillotine. The internal cuts were first made and then the profile. Once cut and a little bit of fettling with needle files, a bracket was silver soldered to the back so it can be attached to the chimney base. Then cleaned up and painted.
![Starting to cut out](resources/Foden_cylinder_block/crest.jpg.opt650x866o0%2C0s650x866.jpg)
![](resources/Foden_cylinder_block/Foden%20crest.jpg.opt650x866o0%2C0s650x866.jpg)